BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / COOLING

Fill and bleed the M20 cooling system

Late rear-wheel-drive E30 325i with the original M20B25 and its separate expansion tank.

IntermediateReplacement steps30–60 min plus cool-downSOURCE-BASED GUIDESource references recorded · technical review pending

Fill and bleed the M20 cooling system

Late rear-wheel-drive E30 325i with the original M20B25 and its separate expansion tank.

Tools

  • 8 mm wrench for the original thermostat-housing bleed screw.
  • Low-range torque wrench, clean funnel and drain pan.

Tightening & service specifications

Original 8 mm wrench-size bleeder
8 NmBMW E30 torque manual · 17-1 · PDF 61
Cold level reference
About 20 °CBMW · 17-8/1, late expansion tank

1991 325i coupe · expansion tank diagram

Replacement steps

Before you start

Late rear-wheel-drive E30 325i with the original M20B25 and its separate expansion tank.

Estimated time
30–60 min plus cool-downPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • 8 mm wrench for the original thermostat-housing bleed screw.
  • Low-range torque wrench, clean funnel and drain pan.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Fresh coolant approved for the installed engine, mixed to the required concentration.

Manual references

17-6 · 17 00 039 and late tank on 17-8/1

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Wait for the engine and coolant to cool completely before opening the system. Catch the coolant and keep it away from children and animals.
  • Stop the engine if the temperature rises abnormally, coolant escapes, or cabin heat drops out when the engine is warm.

Walkthrough

Open the cold system

With the engine off, set the heater to hot. Open the separate expansion tank and loosen the 8 mm thermostat-housing bleed screw.

Check: The open bleeder is at the M20 thermostat housing.

Fill slowly and close the bleeder

Pour into the expansion tank until a steady, bubble-free stream reaches the bleed point. Close the original bleeder at 8 Nm. Set the cold level to the molded mark and install the cap.

Check: The bleeder and cap are seated and the tank is at its cold mark.

Warm, cool and check again

Run in a well-ventilated area and monitor the gauge and cabin heat. Shut down and let everything cool fully. Recheck the level at about 20 °C and inspect the joints and bleed screw for leaks.

Check: The cold level is stable and there is no leak or overheating.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW E30 Repair Manual

17-6 · 17 00 039 and late tank on 17-8/1 · PDF pages 332, 337

Late rear-wheel-drive E30 325i with the original M20B25 and its separate expansion tank.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.