BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / SUSPENSION

Front wishbone bushings

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Use matching left and right bushings and keep their installation marks aligned.

AdvancedReplacement steps1–2 hr per sideSOURCE-BASED GUIDESource references recorded · technical review pending

Front wishbone bushings

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Use matching left and right bushings and keep their installation marks aligned.

Tools

  • BMW 31 2 130 press fixture for the bushing and bracket; feeler gauge for the factory wear check.

Tightening & service specifications

Bushing bracket to carrier
42 NmBMW E30 torque manual · 31-4 · PDF 105
Installed bushing check, clearance A
0.7–1.7 mmCheck the gap at the point in the BMW drawing, with the car at the specified normal load.

BMW catalog parts

1991 325i coupe · front wishbone and bushing diagram

Replacement steps

Before you start

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Use matching left and right bushings and keep their installation marks aligned.

Estimated time
1–2 hr per sidePlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • BMW 31 2 130 press fixture for the bushing and bracket; feeler gauge for the factory wear check.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Matched left and right rubber mounts for the installed wishbones.

Manual references

31-8 · 31 12 130

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Chock the wheels and support the car on rated stands or a lift before removing a wheel. A jack alone is insufficient.
  • The bush is a press fit. Stop if the bracket or press fixture cannot be supported squarely.

Walkthrough

Mark the brackets and check the bushes

Identify each side and record the orientation marks. Confirm the replacement pair is for the six-cylinder RWD arm.

Check: The mounting style and marks match the factory illustration.

Press in the new bushes

Support each bracket in BMW 31 2 130 or the matching fixture. Align its mark with the new bush and press the bush in flush from the beveled end as shown.

Check: Each bush is flush and its marks align with its bracket.

Refit and verify under normal load

Refit the brackets and tighten them to 42 Nm. With the car at normal load, measure clearance A where the workshop drawing shows it.

Check: Clearance A measures 0.7–1.7 mm on both sides.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW E30 Repair Manual

31-8 · 31 12 130 · PDF pages 510

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Use matching left and right bushings and keep their installation marks aligned.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.