BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / SUSPENSION

Rear shocks and upper mounts

1991 U.S. 325i coupe, M20, rear-wheel drive. Conventional rear shocks, without ride-height control.

IntermediateReplacement steps1–2 hr per axleSOURCE-BASED GUIDESource references recorded · technical review pending

Rear shocks and upper mounts

1991 U.S. 325i coupe, M20, rear-wheel drive. Conventional rear shocks, without ride-height control.

The later BMW TIS table gives 77 Nm in its E30 row. Confirm which table and bolt grade apply before tightening the lower mount at normal ride height.

Tools

  • Support jack for the trailing arm and rated stands.
  • Piston-rod counterhold for the fitted shock; size depends on the shaft.

Tightening & service specifications

Upper mount to body
22 NmM8 fasteners.BMW E30 torque manual · 33-17 · PDF 134
Original shock piston rod to upper mount
15 NmFor factory hardware. Use the maker’s value for a replacement shock.BMW E30 torque manual · 33-17 · PDF 134
Lower mount, E30 standard bolt row
87 NmFactory archive, at normal ride height. Verify bolt grade and the table for the installed hardware first.BMW E30 torque manual · 33-17 · PDF 134
Lower mount, E30 10.9 bolt row
130 NmFactory archive, when the bolt is marked 10.9. Check the installed shock and applicable BMW edition.BMW E30 torque manual · 33-17 · PDF 134

BMW catalog parts

U.S. 325i · shock and mount diagram

Replacement steps

Before you start

1991 U.S. 325i coupe, M20, rear-wheel drive. Conventional rear shocks, without ride-height control.

Estimated time
1–2 hr per axlePlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Support jack for the trailing arm and rated stands.
  • Piston-rod counterhold for the fitted shock; size depends on the shaft.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Matched rear shocks or upper mounts as needed, new upper gaskets and applicable self-locking nuts.

Manual references

33-16 · 33 52 000

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Chock the wheels and use a rated lift or stands. Keep the removed assembly supported separately.
  • The shock limits trailing-arm droop. Support the arm before undoing the lower bolt and confirm its grade before tightening.

Walkthrough

Expose the mount and support the arm

Move aside trunk trim. Support the semi-trailing arm before releasing the lower shock bolt. Protect nearby brake hoses and body trim.

Check: The trailing arm remains supported as the shock is unloaded.

Change the shock or upper mount

Remove the upper mount fasteners and withdraw the shock. Replace the gasket. If reusing the mount, inspect its rubber and tighten the original shaft nut to 15 Nm with the correct counterhold. Prime dampers only as their manufacturer specifies.

Check: The gasket sits flat and the mount has no torn rubber or looseness.

Tighten at installed height

Tighten the upper M8 fasteners to 22 Nm. Bring the arm to normal ride position and use the confirmed lower-bolt specification for its grade and source.

Check: The hardware is secure, the arm moves freely, and the trim is refitted.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW E30 Repair Manual

33-16 · 33 52 000 · PDF pages 636

1991 U.S. 325i coupe, M20, rear-wheel drive. Conventional rear shocks, without ride-height control.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.