BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / ELECTRICAL

Replace a sealed-beam headlight insert

U.S. E30 325i with four sealed-beam lamps, the late arrangement cataloged from 06/1989.

BeginnerReplacement steps25–45 minSOURCE-BASED GUIDESource references recorded · technical review pending

Replace a sealed-beam headlight insert

U.S. E30 325i with four sealed-beam lamps, the late arrangement cataloged from 06/1989.

Tools

  • Driver that seats in the grille and three clamping-ring screws. Proper beam-setting equipment for the aim check.

Tightening & service specifications

Outer low-beam insert
H5006
Inner high-beam insert
H5001

BMW catalog parts

1991 325i coupe · late sealed-beam lamp diagram

Replacement steps

Before you start

U.S. E30 325i with four sealed-beam lamps, the late arrangement cataloged from 06/1989.

Estimated time
25–45 minPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Driver that seats in the grille and three clamping-ring screws. Proper beam-setting equipment for the aim check.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Matching sealed-beam insert identified as outer low beam or inner high beam.

Manual references

BMW 325i handbook · p. 60

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Switch off the ignition and disconnect the battery ground before disconnecting the wiring.
  • Stop if the connector shows heat damage or the lamp seat is broken. Have aim checked after refitting.

Walkthrough

Identify the lamp

Use the two outer inserts for low beam and the two inner inserts for high beam. Match the lens marking and connector on the failed unit.

Check: The replacement is the correct beam position and connector type.

Release the clamping ring

Remove the grille section and support the insert while loosening its three ring screws. Unplug the insert without disturbing the beam adjustment screws.

Check: The reflector carrier and adjusters have stayed in place.

Seat and verify the lamp

Engage the insert’s locating features and secure the ring and grille. Restore power and check both beam settings. Have the aiming pattern checked with the correct equipment.

Check: The lamp is seated firmly and lights in the correct switch position.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW 325i / 325is owner’s handbook

BMW 325i handbook · p. 60

U.S. E30 325i with four sealed-beam lamps, the late arrangement cataloged from 06/1989.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.