BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / SUSPENSION

Remove or install a wheel

U.S. E30 325i / 325is, stock wheel and bolts described in the owner’s handbook.

BeginnerReplacement steps15–25 minSOURCE-BASED GUIDESource references recorded · technical review pending

Remove or install a wheel

U.S. E30 325i / 325is, stock wheel and bolts described in the owner’s handbook.

Tools

  • Wheel bolt wrench or matching socket, chock and calibrated torque wrench. Use the wheel-lock key if fitted.

Tightening & service specifications

Wheel bolts
110 Nm (81 lb-ft)This handbook configuration. The BMW torque book gives 100 Nm with +10 Nm tolerance. Use the applicable specification for different wheels.BMW 325i / 325is handbook · p. 58 (PDF 59)

BMW catalog parts

1991 325i coupe · cross-spoke wheel diagram

Replacement steps

Before you start

U.S. E30 325i / 325is, stock wheel and bolts described in the owner’s handbook.

Estimated time
15–25 minPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Wheel bolt wrench or matching socket, chock and calibrated torque wrench. Use the wheel-lock key if fitted.

Check sizes and special fixtures for the installed hardware.

Manual references

36-6 · 36 10 300

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Chock the wheels and support the car on rated stands or a lift before removing a wheel. A jack alone is insufficient.
  • Use 110 Nm for the stock wheel and bolts covered by the U.S. handbook. Check the wheel maker’s spec for aftermarket hardware.

Walkthrough

Chock the car and loosen the bolts

Park on level ground. Loosen each bolt slightly with the wheel on the ground. Raise and support the car at the specified points.

Check: The wheel is off the ground and the car is stable.

Inspect the seats and mating faces

Support the wheel while removing the bolts. Clean the flat hub and wheel mating faces. Check that the replacement bolt seat and length match the wheel.

Check: The wheel sits flat against the hub and all bolts start by hand.

Tighten in a cross pattern

Snug the bolts evenly in a cross pattern, then use the specified torque with the wheel held against turning.

Check: Every bolt reached the applicable torque.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW E30 Repair Manual

36-6 · 36 10 300 · PDF pages 724

U.S. E30 325i / 325is, stock wheel and bolts described in the owner’s handbook.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.