All repair jobsE30 REPAIR LIBRARY
Heater blower resistor replacement Manual procedure references, original DIY guides and owner experience for this job.
Back to part in Workshop Procedures & illustrated guides Replace the heater blower resistor E30 cowl-access resistor plate shown in BMW 64 11 220. Check its connector and fitted housing.
Open guide BMW · 64-11, blower resistor access View in Workshop Tools Driver for the actual cowl cover screws, trim tool and cutters for the original loom tie. Tightening & service specifications
Resistor retention Press-in plate The illustrated plate and connector seat by hand. BMW catalog parts 1991 325i coupe · heater core, valves and blower diagram
BMW E30 factory repair manual 64-11 · 64 11 220 · PDF page 1206
Open BMW-E30-Repair-Manual.pdf in the workshop archive to see the factory illustrations, tools and full procedure.
Written repair steps Replace the heater blower resistor E30 cowl-access resistor plate shown in BMW 64 11 220. Check its connector and fitted housing.
Read the written walkthrough An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.
Replacement steps Before you start E30 cowl-access resistor plate shown in BMW 64 11 220. Check its connector and fitted housing.
Estimated time 30–60 minPlanning estimate for stock hardware in serviceable condition. Review Source-based draft · technical review pending Listed tools & supplies Driver for the actual cowl cover screws, trim tool and cutters for the original loom tie. Check sizes and special fixtures for the installed hardware.
Required parts Resistor plate matched to the installed blower housing and connector. Manual references 64-11 · 64 11 220
Use these page numbers in your copy of the manual.
Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.
Suggest a source or add a correction ↗