BMW E30 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E30 REPAIR LIBRARY

M20 starter terminals

Manual procedure references, original DIY guides and owner experience for this job.

Written steps

Procedures & illustrated guides

M20 starter terminals

1991 U.S. 325i coupe, M20, rear-wheel drive.

Disconnect the battery negative cable before touching the starter leads. Match the stamped terminal number before tightening.

Tools

  • 8 mm, 10 mm and 13 mm six-point sockets for standard M5, M6 and M8 hex nuts, respectively. Confirm the fitted nut profile.
  • Low-range torque wrench covering 5–12 Nm.

Tightening & service specifications

Terminal 30h wire nut (M5)
5 NmWhere the starter has an identified 30h terminal.
Terminal 50 wire nut (M6)
6 Nm
Terminal 30 wire nut (M8)
12 Nm

BMW catalog parts

1991 325i coupe · starter diagram

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

1991 U.S. 325i coupe, M20, rear-wheel drive.

Estimated time
25–45 minPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • 8 mm, 10 mm and 13 mm six-point sockets for standard M5, M6 and M8 hex nuts, respectively. Confirm the fitted nut profile.
  • Low-range torque wrench covering 5–12 Nm.

Check sizes and special fixtures for the installed hardware.

Manual references

12 41 · Starter wiring connections

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗