All repair jobsE30 REPAIR LIBRARY
M20 starter terminals Manual procedure references, original DIY guides and owner experience for this job.
Back to part in Workshop Written steps
Procedures & illustrated guides M20 starter terminals 1991 U.S. 325i coupe, M20, rear-wheel drive.
Disconnect the battery negative cable before touching the starter leads. Match the stamped terminal number before tightening.
Open guide BMW E30 torque manual · 12-6 · PDF 43 View in Workshop Tools 8 mm, 10 mm and 13 mm six-point sockets for standard M5, M6 and M8 hex nuts, respectively. Confirm the fitted nut profile. Low-range torque wrench covering 5–12 Nm. Tightening & service specifications
Terminal 30h wire nut (M5) 5 Nm Where the starter has an identified 30h terminal.
Terminal 50 wire nut (M6) 6 Nm
Terminal 30 wire nut (M8) 12 Nm BMW catalog parts 1991 325i coupe · starter diagram
An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.
Replacement steps Before you start 1991 U.S. 325i coupe, M20, rear-wheel drive.
Estimated time 25–45 minPlanning estimate for stock hardware in serviceable condition. Review Source-based draft · technical review pending Listed tools & supplies 8 mm, 10 mm and 13 mm six-point sockets for standard M5, M6 and M8 hex nuts, respectively. Confirm the fitted nut profile. Low-range torque wrench covering 5–12 Nm. Check sizes and special fixtures for the installed hardware.
Manual references 12 41 · Starter wiring connections
Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.
Suggest a source or add a correction ↗