BMW E30 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E30 REPAIR LIBRARY

Rear shock absorber removal and installation

Manual procedure references, original DIY guides and owner experience for this job.

Written stepsBMW manual 33-16 · 33 52 000

Procedures & illustrated guides

Rear shocks and upper mounts

1991 U.S. 325i coupe, M20, rear-wheel drive. Conventional rear shocks, without ride-height control.

The later BMW TIS table gives 77 Nm in its E30 row. Confirm which table and bolt grade apply before tightening the lower mount at normal ride height.

Tools

  • Support jack for the trailing arm and rated stands.
  • Piston-rod counterhold for the fitted shock; size depends on the shaft.

Tightening & service specifications

Upper mount to body
22 NmM8 fasteners.BMW E30 torque manual · 33-17 · PDF 134
Original shock piston rod to upper mount
15 NmFor factory hardware. Use the maker’s value for a replacement shock.BMW E30 torque manual · 33-17 · PDF 134
Lower mount, E30 standard bolt row
87 NmFactory archive, at normal ride height. Verify bolt grade and the table for the installed hardware first.BMW E30 torque manual · 33-17 · PDF 134
Lower mount, E30 10.9 bolt row
130 NmFactory archive, when the bolt is marked 10.9. Check the installed shock and applicable BMW edition.BMW E30 torque manual · 33-17 · PDF 134

BMW catalog parts

U.S. 325i · shock and mount diagram

Written repair steps

Rear shocks and upper mounts

1991 U.S. 325i coupe, M20, rear-wheel drive. Conventional rear shocks, without ride-height control.

Read the written walkthrough

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

1991 U.S. 325i coupe, M20, rear-wheel drive. Conventional rear shocks, without ride-height control.

Estimated time
1–2 hr per axlePlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Support jack for the trailing arm and rated stands.
  • Piston-rod counterhold for the fitted shock; size depends on the shaft.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Matched rear shocks or upper mounts as needed, new upper gaskets and applicable self-locking nuts.

Manual references

33-16 · 33 52 000

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗