All repair jobsE30 REPAIR LIBRARY
Sunroof panel alignment Manual procedure references, original DIY guides and owner experience for this job.
Procedures & illustrated guides Align the steel sunroof panel E30 factory sliding and tilting steel sunroof with the guide and gate shown in BMW 54 12 004.
Open guide BMW · 54-1, panel height and adjustment View in Workshop Tools Two 4 mm keys for the guide locks, BMW 00 2 102/103 for the adjusters, straightedge, 0.2 mm plastic gauge and low-range torque wrench. Tightening & service specifications
Front panel height 1 mm below roof
Rear panel height 1 mm above roof
Front and rear clearance About 0.2 mm, even front and rear
New panel adjuster screws 3.5 Nm BMW catalog parts BMW E30 factory repair manual 54-1 · 54 12 004 · PDF page 1057
Open BMW-E30-Repair-Manual.pdf in the workshop archive to see the factory illustrations, tools and full procedure.
Written repair steps Align the steel sunroof panel E30 factory sliding and tilting steel sunroof with the guide and gate shown in BMW 54 12 004.
Read the written walkthrough An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.
Replacement steps Before you start E30 factory sliding and tilting steel sunroof with the guide and gate shown in BMW 54 12 004.
Estimated time 45–90 minPlanning estimate for stock hardware in serviceable condition. Review Source-based draft · technical review pending Listed tools & supplies Two 4 mm keys for the guide locks, BMW 00 2 102/103 for the adjusters, straightedge, 0.2 mm plastic gauge and low-range torque wrench. Check sizes and special fixtures for the installed hardware.
Required parts New self-locking panel screws for the six fasteners removed or loosened for adjustment. Manual references 54-1 · 54 12 004
Use these page numbers in your copy of the manual.
Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.
Suggest a source or add a correction ↗