BMW E30 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E30 REPAIR LIBRARY

Left or right tie rod replacement

Manual procedure references, original DIY guides and owner experience for this job.

Written stepsBMW manual 32-8 · 32 21 251

Procedures & illustrated guides

Steering tie rod and outer end

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Rack-and-pinion steering. Match the fitted lock plate and the steering damper arrangement.

Have the alignment checked after replacing steering or suspension links. Counting turns is only a starting setting.

Tools

  • BMW 32 2 070 separator for the outer joint.
  • BMW 32 2 100 for the standard inner joint, or 32 2 110 for the steering-damper version shown. Use pliers on the lock plate.

Tightening & service specifications

Inner tie rod to rack
75 NmUse a new securing plate. Follow the lock plate procedure; do not hammer it.BMW E30 torque manual · 32-5 · PDF 117
Outer tie rod stud to steering arm
36.5 ± 3.5 NmUse the correct locknut or original castle nut and cotter pin design.BMW E30 torque manual · 32-5 · PDF 117
Tie rod adjuster clamp bolt
14 NmFor the clamp bolt shown, at normal load after setting toe.BMW E30 torque manual · 32-5 · PDF 117

BMW catalog parts

1991 325i coupe · steering linkage diagram

Written repair steps

Steering tie rod and outer end

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Rack-and-pinion steering. Match the fitted lock plate and the steering damper arrangement.

Read the written walkthrough

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Rack-and-pinion steering. Match the fitted lock plate and the steering damper arrangement.

Estimated time
1–2 hr per sidePlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • BMW 32 2 070 separator for the outer joint.
  • BMW 32 2 100 for the standard inner joint, or 32 2 110 for the steering-damper version shown. Use pliers on the lock plate.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Tie rod for the installed rack, new securing plate and outer locking hardware.

Manual references

32-8 · 32 21 251

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗