Read before working
- Support the engine and gearbox properly. Do not use transmission bolts to pull a misaligned gearbox against the engine.
- Keep lubricant off the friction surfaces and use the new pressure-plate bolts required by the source.
Walkthrough
Match the clutch stack and lock the flywheel
Record the gearbox code and compare flywheel, disc spline, pressure plate and release hardware. With the gearbox safely removed, secure the flywheel and release the pressure-plate bolts gradually in a uniform pattern while supporting the plate and disc.
Inspect the flywheel, pilot and release parts
Check the flywheel for scoring, cracking and damaged locating pins. Check the pilot bearing, disc splines, fork, pivot and release bearing. Investigate oil contamination before installing new friction parts. Use new flywheel bolts if the flywheel comes off.
Center the disc and torque the pressure plate
Clean the mating surfaces and face the disc as marked. Seat the plate on its locating pins and center the disc with a pilot tool. Tighten the new bolts evenly in stages. For the source’s listed fasteners, grade 8.8 is 24 Nm and grade 10.9 is 34 Nm. Verify the installed fasteners and kit instructions.
Refit release hardware and gearbox
Check the bearing guide material before applying lubricant. The source leaves the plastic guide sleeve dry and specifies different treatment for earlier aluminum. Check fork and bearing engagement and renew the six-speed pivot and spring clip where applicable. Remove the locking fixture and refit the supported gearbox.
Verify disengagement before road testing
Restore the slave cylinder and hydraulic circuit using group 210, bleed if needed and inspect for leaks. Verify clutch pedal return and disengagement with the vehicle secured. Confirm gear engagement, reverse lamp operation and that there are no abnormal sounds before a controlled test.
Repair outcome
Your observations can help the next owner. An outcome report remains owner-reported until reviewed.
210-4–210-6; 230-5–230-6 · PDF pages 228, 229, 230, 235, 236
Factory-type E34 manual clutch covered by group 210, after the gearbox has been removed using its specific group 230 procedure. Confirm whether the installed pressure plate has separate manufacturer-specific installation requirements.
Source coverage, rights and review statusOwner walkthroughs & comments
Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.
Loading owner posts…
Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.