BMW E34 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E34 REPAIR LIBRARY

M50 valve cover gasket

Manual procedure references, original DIY guides and owner experience for this job.

Written stepsManual 116-3

Procedures & illustrated guides

M50 and M50TU valve cover gasket

U.S. E34 525i with the original M50 or M50TU. Confirm the cover and production split at September 1992.

Tools

  • Low-range torque wrench. Check the actual cover fasteners and the coil/ground fasteners before choosing sockets.

Tightening & service specifications

Original M6 valve-cover hardware
10 NmFor the cover-to-head fasteners.Bentley · 116-4, gasket and cover installation

BMW catalog parts

1995 525i sedan · valve cover diagram

SERVICE MANUAL REFERENCE

Bentley Publishers · Cylinder head and valvetrain

Printed 116-3 · PDF 101 · section start for m50 valve cover gasket.

Use the complete procedure, figures, tools and specifications in your copy. 525i, 535i, 530i, 540i U.S. source coverage; confirm production date, engine and equipment. The private scan is not displayed here.

Open this manual reference
Written repair steps

Replace the M50 valve-cover gasket

Reseal the factory cam cover and spark plug wells while preserving coil grounds, cover seals and the specified joint treatment.

Read the written walkthrough

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

Bentley-covered E34 525i with an original M50/M50TU head and cover. Verify the gasket kit, cover type and applicable sealing points. Oil from above the cover or a damaged cover needs a separate repair.

Estimated time
1–3 hoursEditorial estimate for an accessible, source-matching installation.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Light and inspection mirror
  • Lint-free cloths
  • Socket set and ratchet
  • Straight extension
  • Camera or labels
  • Non-marring scraper
  • Low-range torque wrench

Check sizes and special fixtures for the installed hardware.

Required parts

  • Matching perimeter gasket
  • Matching plug-well seals
Parts to inspect or match separately
  • Correct fastener insulators/grommets if deteriorated or required by the selected kit instructions
  • Breather fitting/connector or cover only if damage is found
  • Sealant only at locations and cure conditions specified for the actual gasket/cover product

Stop the job if

  • Wrong/uncertain cover or kit
  • Cracked/distorted cover or damaged mating face
  • Brittle fitting that cannot release normally
  • Unremoved fastener or force required to lift cover
  • Missing ground/bracket/hardware record
  • Gasket will not remain seated
  • Continued oil leak or abnormal running

Manual references

116-3–116-4, M50 cylinder head cover

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗