Printed 116-3 · PDF 101 · section start for m50 valve cover gasket.
Use the complete procedure, figures, tools and specifications in your copy. 525i, 535i, 530i, 540i U.S. source coverage; confirm production date, engine and equipment. The private scan is not displayed here.
An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.
Replacement steps
Before you start
Bentley-covered E34 525i with an original M50/M50TU head and cover. Verify the gasket kit, cover type and applicable sealing points. Oil from above the cover or a damaged cover needs a separate repair.
Estimated time
1–3 hoursEditorial estimate for an accessible, source-matching installation.
Review
Source-based draft · technical review pending
Listed tools & supplies
Light and inspection mirror
Lint-free cloths
Socket set and ratchet
Straight extension
Camera or labels
Non-marring scraper
Low-range torque wrench
Check sizes and special fixtures for the installed hardware.
Required parts
Matching perimeter gasket
Matching plug-well seals
Parts to inspect or match separately
Correct fastener insulators/grommets if deteriorated or required by the selected kit instructions
Breather fitting/connector or cover only if damage is found
Sealant only at locations and cure conditions specified for the actual gasket/cover product
Stop the job if
Wrong/uncertain cover or kit
Cracked/distorted cover or damaged mating face
Brittle fitting that cannot release normally
Unremoved fastener or force required to lift cover
Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.