BMW E34 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E34 REPAIR LIBRARY

M20 timing belt installation and timing verification

Manual procedure references, original DIY guides and owner experience for this job.

Written stepsManual 118-3

Procedures & illustrated guides

M20 timing belt and tensioner

U.S. 1989–90 E34 525i with the original M20 and the timing hardware shown in Bentley.

Use the full timing procedure and prove the timing by hand before starting the engine. The M50 uses a chain.

Tools

  • 22 mm crank socket to turn the crank on the source hardware.
  • 32 mm wrench and pulley holder for the original fan clutch; left-hand thread.
  • Torque wrench and coolant catch pan.

Tightening & service specifications

Tensioner to block
22 ± 2 NmBentley · 118-4, timing belt torques
Vibration damper to crank hub, M8 bolts
22 ± 2 NmPeripheral damper bolts only.Bentley · 118-4, timing belt torques

BMW catalog parts

1990 525i sedan · M20 timing parts diagram

SERVICE MANUAL REFERENCE

Bentley Publishers · Camshaft timing belt

Printed 118-3 · PDF 143 · section start for m20 timing belt installation and timing verification.

Use the complete procedure, figures, tools and specifications in your copy. 525i, 535i, 530i, 540i U.S. source coverage; confirm production date, engine and equipment. The private scan is not displayed here.

Open this manual reference
Written repair steps

Replace the M20 timing belt and tensioner

Expose the factory belt drive, establish cylinder 1 TDC, install the belt with slack at the tensioner and verify the marks through two turns.

Read the written walkthrough

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

U.S. 1989–90 E34 525i with the original M20 timing drive. The M50 uses a chain. Confirm the exact belt, tensioner and cooling-system components before removing anything.

Estimated time
Half dayEditorial estimate for an accessible, source-matching installation.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Matched belt and tensioner
  • 22 mm crank socket for source hardware
  • Fan wrench and pulley holder
  • Torque wrench
  • Coolant recovery pan

Check sizes and special fixtures for the installed hardware.

Manual references

118-1–118-4, Figs. 1–8; 170-5

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗