BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / COOLING

Replace the late M20 expansion tank

Late rear-wheel-drive E30 325i with the original M20B25 and clip-mounted tank from 09/1987.

IntermediateReplacement steps30–60 min plus cool-downSOURCE-BASED GUIDESource references recorded · technical review pending

Replace the late M20 expansion tank

Late rear-wheel-drive E30 325i with the original M20B25 and clip-mounted tank from 09/1987.

Tools

  • 30 mm wrench for the original level switch.
  • Low-range torque wrench, clamp driver, 8 mm bleeder wrench and drain pan.

Tightening & service specifications

Original 30 mm wrench-size level switch
3 NmBMW E30 torque manual · 17-1 · PDF 61

BMW catalog parts

1991 325i coupe · expansion tank diagram

Replacement steps

Before you start

Late rear-wheel-drive E30 325i with the original M20B25 and clip-mounted tank from 09/1987.

Estimated time
30–60 min plus cool-downPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • 30 mm wrench for the original level switch.
  • Low-range torque wrench, clamp driver, 8 mm bleeder wrench and drain pan.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Late expansion tank, correct level-switch seal, coolant and replacement clamps for the opened connections.

Manual references

17-8/1 · 17 11 100

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Wait for the engine and coolant to cool completely before opening the system. Catch the coolant and keep it away from children and animals.
  • Match the late separate tank and all three hose connections before removing the old tank.

Walkthrough

Drain to below the tank

Open the cold cap and catch the coolant. Unplug the level switch and label the lower hoses and small vent line before disconnecting them.

Check: Each hose is identified and isolated clear of the mount.

Transfer the switch and fit the tank

Unclip the tank from its bracket. With a new seal, tighten the original 30 mm wrench-size level switch to 3 Nm. Engage the replacement tank in all bracket clips and reconnect the original hose routing.

Check: The tank is secure and each hose is fully seated without a kink.

Refill and verify

Bleed at the M20 thermostat housing, then recheck the level at about 20 °C. Inspect the tank seams, hose joints and switch seal and check for a low-level warning.

Check: The joint surfaces are dry and the level is stable.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW E30 Repair Manual

17-8/1 · 17 11 100 · PDF pages 337

Late rear-wheel-drive E30 325i with the original M20B25 and clip-mounted tank from 09/1987.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.