BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / SUSPENSION

Front anti-roll bar, links and mounts

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Link mounts to the control arm; use different specs for an iX or M3 strut-mounted design.

IntermediateReplacement steps1–2 hrSOURCE-BASED GUIDESource references recorded · technical review pending

Front anti-roll bar, links and mounts

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Link mounts to the control arm; use different specs for an iX or M3 strut-mounted design.

Tools

  • Counterhold wrench for the flats on the link. Measure the actual bar diameter before buying bushes.

Tightening & service specifications

Link to anti-roll bar
47 NmBMW E30 torque manual · 31-10 · PDF 110
Link pivot bracket to control arm
42 NmBMW E30 torque manual · 31-10 · PDF 110
M8 bar clamp to axle carrier
22 NmBMW E30 torque manual · 31-9 · PDF 109

BMW catalog parts

1991 325i coupe · front stabilizer diagram

Replacement steps

Before you start

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Link mounts to the control arm; use different specs for an iX or M3 strut-mounted design.

Estimated time
1–2 hrPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Counterhold wrench for the flats on the link. Measure the actual bar diameter before buying bushes.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Matched links or mount bushes for the measured bar diameter if replacing them.

Manual references

31-17 · 31 35 000

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Chock the wheels and support the car on rated stands or a lift before removing a wheel. A jack alone is insufficient.
  • Support the front evenly before disconnecting the bar. Confirm it is free of load at the links.

Walkthrough

Identify the layout and measure the bar

Compare the arm-mounted link and clamp positions with the BMW diagram. Measure the bare bar at the bushing seat before ordering rubber mounts.

Check: The link type and bush bore match the car.

Release the bar

Counterhold the links while disconnecting both ends. Release the left wishbone bracket as shown for access and remove both bar mounts.

Check: The bar comes out without contacting the steering or brake lines.

Install and check clearance

Refit the mounts and links, aligning the bar laterally. Tighten the link-to-bar nuts to 47 Nm and the factory M8 clamp fasteners to 22 Nm. Restore any link pivot bracket disturbed during the work to its 42 Nm specification.

Check: Both links articulate and the bar clears nearby components.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW E30 Repair Manual

31-17 · 31 35 000 · PDF pages 530

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Link mounts to the control arm; use different specs for an iX or M3 strut-mounted design.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.