BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / ELECTRICAL

M20 alternator terminals

1991 U.S. 325i coupe, M20, rear-wheel drive.

IntermediateReplacement steps25–45 minSOURCE-BASED GUIDESource references recorded · technical review pending

M20 alternator terminals

1991 U.S. 325i coupe, M20, rear-wheel drive.

Disconnect the battery negative cable before removing the B+ terminal cover.

Tools

  • 13 mm six-point socket for a standard M8 B+ hex nut. Match the D+ nut on the fitted alternator.
  • Low-range torque wrench covering 5–13 Nm.

Tightening & service specifications

D+ signal terminal
5 NmM20 on the BMW 12 31 1AZ table.
B+ output terminal
13 NmM20 on the BMW 12 31 1AZ table.

BMW catalog parts

1991 325i coupe · alternator diagram

Replacement steps

Before you start

1991 U.S. 325i coupe, M20, rear-wheel drive.

Estimated time
25–45 minPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • 13 mm six-point socket for a standard M8 B+ hex nut. Match the D+ nut on the fitted alternator.
  • Low-range torque wrench covering 5–13 Nm.

Check sizes and special fixtures for the installed hardware.

Manual references

12 31 · M20 alternator terminals

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Let the engine cool before working around the plugs, fan or exhaust.
  • Disconnect the battery negative cable before touching B+. Do not bridge a live output terminal to the case.

Walkthrough

Identify the terminals

Use the matching electrical diagram and alternator markings to distinguish B+ from D+. Photograph the cable positions before disconnecting anything.

Check: The alternator label and both terminal markings are readable.

Refit and tighten

Clean the mating faces and reinstall the leads without letting the studs turn. Use 13 Nm on factory M20 B+ and 5 Nm on D+ after confirming the alternator type.

Check: Both leads sit flat and the terminal insulation is intact.

Restore insulation and test

Refit the B+ cover before reconnecting the battery. Verify that the charge warning lamp comes on with ignition and goes out after starting.

Check: The wiring is covered and the warning lamp behaves normally.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.