BMW E30 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / COOLING

Replace the late M20 manual radiator

Late rear-wheel-drive E30 325i with the original M20B25 and manual transmission. Check A/C equipment before matching the radiator and thermoswitch.

IntermediateReplacement steps1–2 hr plus cool-downSOURCE-BASED GUIDESource references recorded · technical review pending

Replace the late M20 manual radiator

Late rear-wheel-drive E30 325i with the original M20B25 and manual transmission. Check A/C equipment before matching the radiator and thermoswitch.

Tools

  • 10 mm socket for an original M6 hex-head mount. Use the drive profile supplied with the actual drain plug.
  • Low-range torque wrench covering 2.5–10 Nm, clamp driver, catch pan and gloves.

Tightening & service specifications

Radiator mount screw, M6
10 NmBMW E30 torque manual · 17-2 · PDF 62
Original-type radiator drain plug
2.5 NmBMW E30 torque manual · 17-2 · PDF 62
Original 32–48 mm coolant hose clamps
2.5 NmBMW E30 torque manual · 17-1 · PDF 61

BMW catalog parts

1991 325i coupe · radiator and supports diagram

Replacement steps

Before you start

Late rear-wheel-drive E30 325i with the original M20B25 and manual transmission. Check A/C equipment before matching the radiator and thermoswitch.

Estimated time
1–2 hr plus cool-downPlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • 10 mm socket for an original M6 hex-head mount. Use the drive profile supplied with the actual drain plug.
  • Low-range torque wrench covering 2.5–10 Nm, clamp driver, catch pan and gloves.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Radiator for the late manual 325i, approved coolant and any failed mounts or hose clamps.

Manual references

17-7 to 17-7/1 · 17 11 000

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • Wait for the engine and coolant to cool completely before opening the system. Catch the coolant and keep it away from children and animals.
  • This procedure covers the manual-transmission radiator. An automatic has separate cooler lines and requires an ATF level check.

Walkthrough

Drain and free the shroud

Disconnect the battery ground. Catch the coolant at the lower drain. Release the shroud retainers and lift or park the shroud as the manual shows. Disconnect the hoses and any temperature-switch plug.

Check: The radiator can move without pulling hoses or wiring.

Lift the radiator and transfer hardware

Remove the upper mounting hardware. Lift the radiator out of its rubber supports. Check the supports, shroud, drain plug and any used temperature-switch seal before transferring hardware.

Check: The replacement core and lower locating pegs match the original.

Fit, refill and leak-check

Seat the radiator on its supports. Tighten the original M6 mount to 10 Nm and the catalog-style drain plug to 2.5 Nm. Reconnect the switch, hoses and shroud. Follow the M20 fill and bleed guide before checking for leaks and fan clearance.

Check: The housing is supported and the fan turns without shroud contact.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW E30 Repair Manual

17-7 to 17-7/1 · 17 11 000 · PDF pages 333, 334

Late rear-wheel-drive E30 325i with the original M20B25 and manual transmission. Check A/C equipment before matching the radiator and thermoswitch.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.