BMW E30 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E30 REPAIR LIBRARY

Driveshaft center support inspection and replacement reference

Manual procedure references, original DIY guides and owner experience for this job.

Inspection notesBMW manual 26-10 to 26-11 · 26 12 001

Procedures & illustrated guides

Driveshaft center support

1991 U.S. 325i coupe, M20, rear-wheel drive. Two-piece shaft with the late center mount. Check the shaft and flange before ordering.

Keep the two shaft halves indexed. Support the shaft and use the full procedure before loosening the bracket.

Tools

  • BMW 26 1 040 for the threaded sleeve.
  • Bearing puller and BMW 24 1 050 driver for fitting the support.

Tightening & service specifications

Center mount to body
21 NmBracket fasteners; follow the shaft installation and preload procedure first.BMW E30 torque manual · 26-2 · PDF 99
Sliding joint clamp ring
10 NmFactory rear-wheel-drive E30 ring after installation in the car. BMW lists a different value for the iX.BMW E30 torque manual · 26-1 · PDF 98

BMW catalog parts

1991 325i coupe · center mount diagram

BMW E30 factory repair manual

26-10 to 26-11 · 26 12 001 · PDF pages 466–467

Open BMW-E30-Repair-Manual.pdf in the workshop archive to see the factory illustrations, tools and full procedure.

Inspection before repair

Inspect the driveshaft center support

Find the support at the shaft joint, inspect the rubber and mounting bracket, and find the illustrated replacement procedure.

Read the notes

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Inspection

Before you start

Rear-wheel-drive E30 325i with the illustrated two-piece shaft. Confirm flange, bearing and bracket details from your build. The iX and M3 need their own catalog and procedure checks.

Estimated time
20–40 min inspectionEstimate for visual checks with safe access. Shaft removal, bearing work and road testing take additional time.
Review
Source-based draft · technical review pending

This inspection helps decide the next action. It does not include the resulting repair.

Listed tools & supplies

  • Torch
  • Inspection mirror
  • Camera
  • Lift or rated vehicle supports for underbody access

Check sizes and special fixtures for the installed hardware.

Manual references

26-03 through 26-04 for shaft removal, 26-10 through 26-11 for the center mount

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗