BMW E34 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / BODY

Replace the hood support struts

Support the hood independently, release each end clip and verify both struts are locked onto their mounting studs.

BeginnerReplacement steps20–40 minSOURCE-BASED GUIDESource references recorded · technical review pending
Replacement steps

Before you start

Bentley-covered E34 with the original clip-retained hood gas struts. Match the replacement length, end fittings and orientation.

Estimated time
20–40 minEditorial estimate for an accessible, source-matching installation.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • Matched pair of hood supports
  • Secure independent hood support and helper
  • Small flat trim tool
  • Eye protection

Check sizes and special fixtures for the installed hardware.

Manual references

410-4, Fig. 10

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • A weak gas strut can release unexpectedly. Support the hood independently for the entire job and work on one side at a time.
  • Gas struts are pressurized. Keep them away from heat and do not open the cylinder.

Walkthrough

Secure the hood fully open

Park on level ground, open the hood and place an independent support that cannot slide off. Keep a helper in position and note the strut orientation and stud condition.

Check: The hood’s weight is held independently and the new struts match.

Release one strut at both studs

Raise the retaining clip just enough to unlock the end and slide the socket off its stud. Repeat at the opposite end while supporting the strut. Inspect studs and retainers for damage.

Check: The first strut is free and both mounting studs are sound.

Seat and test the replacement ends

Match the original orientation and seat both ends fully. Restore each clip and tug lightly to confirm retention. Repeat on the other side.

Check: All four ends are positively retained.

Verify support through the hood travel

With the helper still holding the hood, remove the independent support. Move the hood slowly and check that it stays up and closes without binding. Reinstall the support if it does not.

Check: The hood holds open and closes and latches normally.

Repair outcome

Your observations can help the next owner. An outcome report remains owner-reported until reviewed.

BMW 5 Series (E34) Service Manual

410-4, Fig. 10 · PDF pages 336

Bentley-covered E34 with the original clip-retained hood gas struts. Match the replacement length, end fittings and orientation.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.