Printed 117-18 · PDF 138 · section start for m50tu vanos removal and installation.
Use the complete procedure, figures, tools and specifications in your copy. 525i, 535i, 530i, 540i U.S. source coverage; confirm production date, engine and equipment. The private scan is not displayed here.
An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.
Replacement steps
Before you start
Factory U.S. E34 M50TU single intake VANOS, original timing drive. Use this with 117-18–20 and its figures at the bench. Internal actuator seal replacement is a separate bench operation.
Estimated time
Half dayEditorial estimate for an accessible, source-matching installation.
Review
Source-based draft · technical review pending
Listed tools & supplies
BMW 11 2 300 crank pin
BMW 11 3 240 camshaft alignment fixture
BMW 11 3 390 dummy tensioner
E10 socket
Low-range torque tools
New actuator gasket and applicable seals
Check sizes and special fixtures for the installed hardware.
Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.