Printed 210-5 · PDF 229 · section start for clutch inspection, alignment and installation.
Use the complete procedure, figures, tools and specifications in your copy. 525i, 535i, 530i, 540i U.S. source coverage; confirm production date, engine and equipment. The private scan is not displayed here.
An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.
Replacement steps
Before you start
Factory-type E34 manual clutch covered by group 210, after the gearbox has been removed using its specific group 230 procedure. Confirm whether the installed pressure plate has separate manufacturer-specific installation requirements.
Estimated time
2–4 hours after gearbox removalEditorial estimate for an accessible, source-matching installation.
Review
Source-based draft · technical review pending
Listed tools & supplies
Matched clutch kit and new fasteners
Flywheel holding fixture
Clutch pilot alignment tool
Torque wrench
Correct lubricant for specified contact points
Transmission jack
Check sizes and special fixtures for the installed hardware.
Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.