BMW E30 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E30 REPAIR LIBRARY

Front strut removal and installation

Manual procedure references, original DIY guides and owner experience for this job.

Written stepsBMW manual 31-11 · 31 31 000

Procedures & illustrated guides

Front strut, upper mount and damper

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Check the damper and upper mount type before applying shaft torque.

Support the strut and use a spring compressor that fits the spring. Never loosen the center nut while the spring is loaded.

Tools

  • BMW 31 3 111 spring compressor with the fitting shown, and 31 3 170 shaft-nut tool with a counterhold.
  • BMW 31 3 150 or 31 3 180 retaining-ring tool, according to the installed collar.

Tightening & service specifications

Upper mount to body
22 NmReplace the self-locking nuts.BMW E30 torque manual · 31-7 · PDF 107
Damper shaft nut, original M12 external hex shaft
64 NmBMW E30 torque manual · 31-7 · PDF 107
Damper shaft nut, original M12 internal hex shaft
44 NmBMW E30 torque manual · 31-7 · PDF 107
Original damper retaining collar
130 NmCheck replacement damper instructions if the supplied ring differs.BMW E30 torque manual · 31-8 · PDF 108

BMW catalog parts

1991 325i coupe · front strut and damper diagram

Written repair steps

Front strut, upper mount and damper

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Check the damper and upper mount type before applying shaft torque.

Read the written walkthrough

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Check the damper and upper mount type before applying shaft torque.

Estimated time
2–4 hr per sidePlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • BMW 31 3 111 spring compressor with the fitting shown, and 31 3 170 shaft-nut tool with a counterhold.
  • BMW 31 3 150 or 31 3 180 retaining-ring tool, according to the installed collar.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Matched strut inserts or mount components as required and new upper-mount locking nuts.

Manual references

31-11 to 31-14 · 31 31 000 / 31 32 001

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗