BMW E30 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E30 REPAIR LIBRARY

Front control arm removal

Manual procedure references, original DIY guides and owner experience for this job.

Written stepsBMW manual 31-6 · 31 12 000

Procedures & illustrated guides

Front control arm replacement

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Factory steel wishbones; use the separate procedure for the 325iX or M3.

Have the alignment checked after replacing steering or suspension links. Counting turns is only a starting setting.

Tools

  • BMW 31 1 110 ball joint separator for the standard strut.
  • Torque wrench covering 42–85 Nm. Use the socket that fully fits each replacement nut.

Tightening & service specifications

Inner ball joint to front axle carrier
85 NmBMW E30 torque manual · 31-3 · PDF 104
Outer ball joint to spring strut
65 NmKeep the taper and bore clean and free of grease. Install the locking hardware specified for each joint.BMW E30 torque manual · 31-3 · PDF 104
Control arm bushing bracket to carrier
42 NmBMW E30 torque manual · 31-4 · PDF 105

BMW catalog parts

1991 325i coupe · front wishbone and bushing diagram

Written repair steps

Front control arm replacement

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Factory steel wishbones; use the separate procedure for the 325iX or M3.

Read the written walkthrough

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. Factory steel wishbones; use the separate procedure for the 325iX or M3.

Estimated time
1–2 hr per sidePlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • BMW 31 1 110 ball joint separator for the standard strut.
  • Torque wrench covering 42–85 Nm. Use the socket that fully fits each replacement nut.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Wishbone for the correct side and its locking hardware.

Manual references

31-6 · front wishbone replacement

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗