BMW E30 TECHNICAL REFERENCEService manual
Source library
All repair jobs
E30 REPAIR LIBRARY

Rear-wheel-drive front hub and bearing replacement

Manual procedure references, original DIY guides and owner experience for this job.

Written stepsBMW manual 31-10 to 31-10.1 · 31 21 180

Procedures & illustrated guides

Front hub and wheel bearing

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. RWD stub axle with a hub and integral bearing. The 325iX bearing is pressed into a different assembly.

Tools

  • 36 mm thin-wall six-point socket for the original M24 collar nut (BMW 11 2 180).
  • BMW 31 2 101 / 102 / 104 hub puller set and 31 2 120 installer, or the correct equivalents.
  • Torque wrench rated for 290 Nm; staking tool for the new nut.

Tightening & service specifications

New front collar nut to stub axle
290 NmStake the new collar nut after tightening. Replace the grease cap.BMW E30 torque manual · 31-6 · PDF 106

BMW catalog parts

1991 325i coupe · front hub and wheel bearing diagram

BMW E30 factory repair manual

31-10 to 31-10.1 · 31 21 180 · PDF pages 514–515

Open BMW-E30-Repair-Manual.pdf in the workshop archive to see the factory illustrations, tools and full procedure.

Written repair steps

Front hub and wheel bearing

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. RWD stub axle with a hub and integral bearing. The 325iX bearing is pressed into a different assembly.

Read the written walkthrough

An illustrated DIY guide hasn’t been linked to this job yet. Use the manual reference and the written notes, or share an original walkthrough below.

Replacement steps

Before you start

1991 U.S. E30 325i coupe, original rear-wheel-drive front axle. RWD stub axle with a hub and integral bearing. The 325iX bearing is pressed into a different assembly.

Estimated time
1–2 hr per sidePlanning estimate for stock hardware in serviceable condition.
Review
Source-based draft · technical review pending

Listed tools & supplies

  • 36 mm thin-wall six-point socket for the original M24 collar nut (BMW 11 2 180).
  • BMW 31 2 101 / 102 / 104 hub puller set and 31 2 120 installer, or the correct equivalents.
  • Torque wrench rated for 290 Nm; staking tool for the new nut.

Check sizes and special fixtures for the installed hardware.

Required parts

  • Hub with integral bearing, collar nut and grease cap.

Manual references

31-10 to 31-10.1 · 31 21 180

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.

Suggest a source or add a correction ↗