BMW E34 TECHNICAL REFERENCEService manual
Source library
Repair walkthroughs
WORKSHOP GUIDE / BRAKES

Measure brake pad and rotor wear

Check inner and outer pads and compare rotor measurements with the stamped or verified limit for the installed brakes.

IntermediateInspection45–90 minSOURCE-BASED GUIDESource references recorded · technical review pending
Inspection

Before you start

Bentley-covered U.S. cars with conventional disc brakes. Identify any nonfactory caliper, pad and rotor before comparing wear figures.

Estimated time
45–90 minEditorial estimate for an accessible, source-matching installation.
Review
Source-based draft · technical review pending

This inspection helps decide the next action. It does not include the resulting repair.

Listed tools & supplies

  • Proper lifting equipment and stands
  • Light
  • Pad gauge
  • Brake disc micrometer
  • Wheel torque wrench

Check sizes and special fixtures for the installed hardware.

Manual references

020-16; 340-3–340-7, Table b

Use these page numbers in your copy of the manual.

Process pictures are not indexed for this guide. Use the cited manual’s figures alongside the steps.

Read before working

  • If the pedal sinks, fluid is leaking or braking is impaired, arrange recovery. Keep brake dust out of the air and support the vehicle before removing wheels.
  • Use the installed rotor’s specification. The dash wear indicator samples only selected pads.

Inspection steps

Record symptoms and identify the brakes

Note wheel position, pull, vibration, noise and warnings. Identify rotor dimensions and the actual caliper and pad setup. Obtain the correct wear limit for those parts.

Check: The measurements can be compared with the matching specification.

Measure lining separately from the backing plate

With the car safely supported, inspect inner and outer pad linings on both sides of the axle. Look for taper, contamination and uneven wear. If visibility is poor, use the applicable caliper access procedure.

Check: Every inspected pad has a measured lining thickness or a note that it was inaccessible.

Measure the disc at multiple points

Read the marked rotor minimum or confirm the matching part specification. Measure the swept disc away from the outer lip at several points and record the smallest value. Record cracking, scoring or heavy corrosion separately.

Check: Disc thickness and surface condition are recorded for each side.

Act on the weakest measurement

Compare the actual minima with the proper limits. Uneven pad wear needs a sliding or piston check before parts are replaced. Refit the wheels using the applicable wheel-bolt torque. Keep the car off the road if the brakes are unsafe.

Check: There is a clear repair decision for both sides of the axle.

Record your findings

Keep observations and unresolved questions in your private journal before deciding on a repair.

Add to My garage ↗
BMW 5 Series (E34) Service Manual

020-16; 340-3–340-7, Table b · PDF pages 38, 319, 320, 321, 322, 323

Bentley-covered U.S. cars with conventional disc brakes. Identify any nonfactory caliper, pad and rotor before comparing wear figures.

Source coverage, rights and review status

Owner walkthroughs & comments

Share how the repair went on your car, add a missing detail, or ask a question. Replies stay with the post so the next owner can follow the whole fix.

Loading owner posts…

Owner experience is community advice. Check the vehicle, source and outcome. Sign in to publish, or submit as a guest for review. Photo and video links open on their original sites.